Wear range of cylinder liners in each section of the carbon dioxide compressor
Thread Content
What is the wear range of the cylinder liners in each section of our 4M32-186 carbon dioxide compressors, which are manufactured by Shanghai Dalong Compressors? This post was last edited by 1025199692 on 2009-4-8 at 13:26.]
Can Haiyou provide this data, and where can it be found? It’s not in our instructions
Our experience shows that for cylinder diameters of DN100 and below, the allowable wear rate is 0.5 percent; for diameters of DN200 and below, it is less than 0.5 percent. For diameters between DN200 and DN300, the allowable wear rate is less than 0.4 percent. For diameters of DN400 and below, it is 0.3 percent, while for diameters of DN500 and above, it is 0.2 percent. It should be available in the compressor manual.