Thread Content
How to use DM1010 Microcomputerized Calcium Iron Coal Analyzer 1. Check whether the power supply voltage is consistent with the working voltage required by the instrument - 220 volts and 50 Hz. 2. Boot sequence: Turn on the power switch of the voltage regulator. After the voltage reading is stable, turn on the power switch of the calcium iron coal analyzer. The instrument will not work within thirty minutes after it is turned on. 3. When the content light of the instrument is on, press the "Start" button, the sample slide slowly moves out from the right side, and the operator puts the sample into the sample hole (if there is a sample in the sample hole, take it away first, and the time for taking away and placing the sample shall not exceed 8 seconds). The sample automatically moves to the measurement position, and then the display displays the percentage content of CaO, Fe2O3, and CoaL in sequence, and the measurement time, mill number, and percentage content of CaO, Fe2O3, and CoaL are printed on the printer. 4. After the measurement is completed, the sample will not exit automatically but will remain in the machine. Generally, there is no need to take it out. It can be taken out during the next measurement. 5. Shutdown sequence: First turn off the power switch of the instrument, then turn off the voltage regulator, and unplug the power plug. Do not turn on the power switch within 30 seconds after turning it off, otherwise the performance of the instrument will be damaged. 6. Operators are not allowed to tamper with the panel buttons, rear panel switches, knobs, and the inserted k and b values of the calcium ferrocoal analyzer. Otherwise, it will cause measurement errors and damage the instrument. In actual operation, only "one press" and "one release" are enough.