When the temperature transmitter alarms, does the alarm value also need to be reflected in the data table?
Thread Content
When the temperature transmitter alarms, does the alarm value also need to be reflected in the data table? Because there is no such column in the standard form. If it does not need to be written in the data table, in which picture can this alarm value be reflected?
There must be alarm values on the PI&D diagram
Can you write it in the remarks of the data sheet?
1. It will be in the PI&D diagram! 2. If it is more important, the Lord will also ask you to add it. 3. The alarm does not occupy any resources, it is just a setting within the DCS. As long as it is displayed in the configuration screen.
I just asked around and found out that an alarm interlock setting value table is enough.
This alarm method can be realized in the configuration mode, that is, the high alarm value or the high alarm value can be set accordingly, which is what the author said that the specific value is displayed when alarming.