Seek advice on how to draw a star-shaped discharge valve
Thread Content
I would like to ask for a simple way to draw the star-shaped material feeding valve in a process flow diagram. Thank you. This post was last edited by yu*nyang_01 on 2009-4-16 at 10:55
First, draw the valve housing: draw the outer shape and subtract the valve core body. Then draw the valve core cylinder: cut out a groove. Finally, it is combined using 3D alignment. In short, it’s hard to explain in just a few words – what kind of drawing do you want? Give me your email address and I’ll draw one for you and send it over. This post was last edited by Fishing for big fish on 2009-4-15 12:38.]