Wheel alignment
Thread Content
What is the specific method for aligning the three gauges on the wheel?
An axial and radial sensor is installed at a certain point, and another sensor is placed at the 180-degree position relative to that point to measure the axial value. Read the values for 90, 180, 270, and 360 degrees respectively. After obtaining the numbers, calculations are first performed to eliminate the effect of shaft play; thereafter, the actually calculated axial and radial values are substituted into the alignment formula to yield the result.
The original poster seems to have asked this question, and the replies below are quite detailed. http://bbs.hcbbs.com/thread-442246-1-5.html
Thank you to the person above; http://bbs.hcbbs.com/thread-442246-1-5.html is very useful
Based on the wheel structure, a specialized watch holder must be designed; this holder is to be installed on one of the wheels, while the other end should enable the watch to be positioned on that wheel – two components in the axial direction and one in the radial direction.