polyethylene kill system
Thread Content
UNIPOL PE's reaction killing system is divided into five types. What is the basis for this classification?
Reaction kill system? This is the first time I've heard of it. . . Sweat:L
Kill the system? I’ve never heard of it. I thought it was the poster who wanted to use PVC for the brake system. It’s too powerful.
Haha, it turns out I'm not the only one who didn't know. . . :lol
The author of this post? ? ? It seems that no one understands
The author of this post? ? ? It seems that no one understands
The author of this post? ? ? It seems that no one understands
UNIPOL PE's reaction killing system is divided into five types. What is the basis for this classification? Mainly based on the degree of risk. type 1 kill: The condition is that the reactor temperature exceeds the set value by 7 degrees Celsius or the reaction temperature exceeds a certain value. CO is injected with the compressor running and the killing agent circulates in the reaction system. type 3 kill: The compressor cannot run, but the turbine can be started, and the turbine is used to drive the fluidized bed to circulate CO in the system. Type 2 kills the most: Type 3 kill fails and Type 2 kill is automatically initiated. The valve on the circulating air line is closed. After Type 2 is killed, the reactor must be cleaned. micro kill: If the reaction temperature is high or the load needs to be reduced quickly, micro-killing can be performed. Generally, each micro-killing can reduce the load by about 10%. Of course, this has something to do with the time it takes to kill the system. Manual kill: On-site manual switch to perform kill. If indoor control fails, kill on site.
There really is a killing system. . . Learned a lot