How to learn *DCS?
Thread Content
For those who have just graduated and started working, how can they learn to operate a DCS? Are there any targeted materials available for this purpose? Thank you!
The best way is to learn on the spot*, by operating the system directly, and then study with relevant materials*. It would be best if someone could give an introduction.
First learn the *basic knowledge, and then tackle each aspect through practical applications. Reading books alone is very ineffective.
DCS is just a software, and its operation is very simple. What you need to learn is the process flow controlled by a DCS control system; that is, you must first learn about the production process, its principles, and the methods of operation. How to use control valves, etc.
Just reading books doesn’t yield very good results. It would be best to be able to attend the manufacturer’s training. Honeywell’s and Yokogawa’s products are both of high quality! They are all on the plane; you will have a visceral understanding of it.
1. If possible, first take a brief look at the technical specifications for DCS bidding for a particular project in order to understand the key points. 2. If possible, use a project that has already been implemented as a reference, and by examining flowcharts, control groups, trend displays, alarms, fault information, and interlock operation interfaces, identify the key aspects to learn. 3. Find the product manual and configuration software from a DCS manufacturer (a trial version will suffice; an official version is even better). 4. Gather project-related materials to carry out configuration exercises. 5. When encountering problems, consult books or the Internet; it would be great if someone experienced could provide guidance. 6. Keep working hard... Wishing you success in becoming an expert in DCS soon.
I’m currently learning on my own; I really wish someone could guide me, as I really want to learn well and create a project of my own.
I’m a beginner too. I went to my own factory’s DCS engineer station to learn from the engineers. But it seems they’re not professional either, so I learn on my own by reading books, studying the manufacturer’s logical design specifications, and looking at SAMA diagrams. I haven’t started learning *configuration yet.
I really want to learn some instructions in this area~ It seems that what I learned in school is quite different from what’s used in practice~