How to calculate the load of the equipment foundation?
Thread Content
How to calculate the load of the equipment foundation? How can we ensure the foundation to ensure the installation and operation of the equipment without making too big a foundation! ! ! ! ! ! ! ! ! ! ! ! ! ! ! ! This post was last edited by Lai Lai on 2009-4-17 18:28 ]
according to* * Corresponding specification calculations!
Under normal circumstances, our factory’s calculation of the equipment basis is as follows:: First look at how many tons the equipment weighs and convert it into force, then look at the bearing capacity of the foundation and then determine the foundation width based on the size of the equipment. Also, determine the distance from the hole to the edge and the depth of the foundation based on the reserved bolt holes or embedded iron. Of course, these must comply with the requirements of the specifications. Take a look at the HGT20643-98 chemical equipment foundation design regulations and the power machine foundation design specifications GB50040-96. This will be helpful to you.
This requires setting conditions with the civil engineering major, including the net weight, water filling weight and operating weight of the equipment, and the load-bearing contact surface area of the equipment must be given to the civil engineering major so that the civil engineering major can design an appropriate load-bearing structure according to the requirements. For towers of more than 100 tons seen at the construction site, the foundation below is only slightly larger than the bottom area of the tower.