How to get the original value
Thread Content
In CAD 2007, when I am editing dimensions, I enter the new value, click OK, select the object, and press Enter; then both the old value and the new one appear there. How can I modify it so that the new value replaces the old one?
There are also such cases; I haven’t encountered them with 06. It can’t be that there are two standards that overlap, right?:)
It should be stacked together; just delete the old ones
Are the two annotations not in the same place, with a slight error, which is why there are two annotations?
It’s likely that you didn’t delete the original value during the editing process. Or overwrite the original value directly during editing later.
Thank you. Then how can I overwrite the original one during editing?
It is recommended that the original poster first determine whether this is indeed the case; only by addressing the specific issues mentioned by others can an appropriate solution be found. First, check whether there is duplicate labeling – that is, whether the labeling has been done twice – or try deleting and re-labeling to see if the problem persists. It might just be a minor issue that was overlooked.