How to solve problems when installing and running ASPEN DYNAMICS
Thread Content
This post was last edited by CYP1983 on 2009-7-23 10:27. I am using the ASPEN PLUS11.1 version, which has been used for static simulation and runs normally. After I successfully installed the component ASPEN DYNAMICS and opened the created file .APW or its corresponding .bkp file with the original ASPEN PLUS11.1, the error message "Failed to create scripted engine, the specified module could not be found" appeared. Therefore static simulation files cannot be exported to create * .dynl or * .appdf file. I can enter ASPEN DYNAMICS11.1 but when performing any operation, the same error message will appear. Please give some advice.
Please help me, experts, I will give you extra points
ASPEN PLUS can be used again after uninstalling ASPEN DYNAMICS. I really don’t know what the reason is
Don’t Sichuan friends encounter similar problems? ?
We have never encountered similar problems. We have both plus and dynamic installed at the same time. You can try uninstalling Aspen and reinstalling it. Select these two modules at the same time during installation.
5# fanweil Thank you for your help. After uninstalling it, there is really no problem after installing it. At first, I just re-run the installation program based on the original ASPEN PLUS, adding module options. Hahaha thank you so much.
6# CYP1983 You’re welcome, let’s learn together* progress.
Mine is the first time I installed it and ran into a problem like the original poster. I don’t know how to solve it.