Problems with igniting and heating the gasifier
Thread Content
What are the reasons for flash explosions during the ignition and heating-up of a gasification furnace?
The ratio of air to liquefied gas is not proportional; when the two mix in the environment, they reach the explosive limit. Pay attention to the sequence of actions before ignition
Rating record reference for this post – the record shown when clicking on “Number of ratings” above is applicable. +2 Wealth points (GSP) for starting a topic. Stop asking questions to yourself, haha. How do you keep focusing on the problem? Weren’t I already explaining it last time?
After the furnace shutdown, thorough purging was not carried out before restarting the ignition, or exhaust gas discharge is poor
I’m sorry; it was my mistake. Let me answer your question, haha. The main reason is incomplete purging and replacement of the furnace before ignition; the second reason is poor oxygen purity.
It was likely that the evacuation time before ignition was insufficient, resulting in inadequate replacement of the air. After the evacuation process was stopped, natural gas leaked, and an excess amount of natural gas inside the furnace caused a flash explosion. Our factory experienced such an incident once, which weakened the furnace’s brick structure significantly, causing serious damage to the gasification furnace
1. In the combustion environment, the nitrogen content should not be too high. 2. The ratio between air and fuel should not deviate too much
New to this field, just starting to learn *gasification technology