HG20592~HG20615-2009 Errata Sheet
Thread Content
This post was last edited by happy75 on 2009-8-9 15:03 at http://bbs.51cysb.com/thread-42597-1-1.html. The error correction list is incomplete and contains mistakes. Personal modifications are attached for reference only. Additionally, the following corrections are made: 1. In Table 3.2.5-1 on page 17, the seal surface dimension d” for the DN350-PN16 flange should be “438” instead of “428”. 2. In Table 8.2.4-3 on page 285, the bolt size “M14” corresponding to DN600-NPS24 should be “M48x3”” ； The corresponding bolt hole diameter of “16” should be “51”. 3. On the 10th line from the bottom of the introduction section (page II), “PN0.25～PN40” should be changed to “PN2.5～PN40”.
Downloads are not possible without registration, and downloads cannot be carried out if there is insufficient balance in the currency used for payment. Could some kind person send it to my email? Or post it so everyone can share it! I think everyone will be grateful to you
It’s good to admit mistakes and make corrections. Thanks for the information, OP!
2# zhangjian006 You can tell me your email address.
zhuzongzhang@163.com is my email address; thank you, handsome guy!
wangke5687@163.com is my email address. Could you send me one as well? I would be extremely grateful!
Go straight to the equipment central station to board or disembark; the new corrigendum for September 1st is already available.
Question: Why is there such a big difference in thickness and weight between flanges of standard 09 and standard 97 for SO600-16 – 107.5/77 kg?