How is the pressure of the two units in Beijing Dongfang Simulation Catalytic Cracking controlled?
Thread Content
This post was last edited by kaminocmyhc on 2009-9-1 15:05. How can the pressures of the two vessels be controlled when switching the gas seal during the startup of the Beijing Dongfang Simulation Catalytic Cracking reactor? (The pressure in the regenerator is 0.1 MPa, and the pressure in the settler is 0.11 MPa.) How can those 60 mass percentages be determined? Thank you
Oriental did a mediocre job; our company used their services, but we stopped using them altogether later on
Is the East that bad? Our school still plans to use their equipment, haha
Question: How is the pressure in the two reactors controlled when removing the large blind flange during the startup of the Beijing Dongfang simulated catalytic cracking reactor? (The pressure in the regenerator is 0.1 MPa, and the pressure in the decompressor is 0.11 MPa.) How is that 60% mass fraction determined? Thank you
It’s quite good for use in schools; it helps to enhance understanding of them. Our school bought a few sets. There are many things that were unclear in school simulations but became clear once I started working in production.
I hope everyone will discuss more; I hope there will be plenty of discussion