How do I set up an analog PLC program in AB RSLogix Emulate 500? I’ve seen it, can’t find it anymore, thanks!
Thread Content
This post was last edited by meetkey on 2009-8-19 at 15:49. RT; thanks to everyone for their help. I’ve just started learning about *AB.
I managed to do it on my own, but thanks anyway to everyone. Feel free to discuss AB with me.
Let’s share our experiences so we can all improve together!
The software has been installed, right? RSlinx, to install the drivers; I’m using an SCL 500, which simulates a Micrologix 1500 LRP ； RSLogix Emulate 500: open the program you want to simulate, then run it ； RSlogix 500 Pro: go to the Communication menu, then System Communication; find the PLC you have simulated, and connect it to the system – that’s it. Selecting to go live directly from the interface toolbar may not necessarily succeed; I tried it several times and it happened the same way each time. I don’t know why for now. During the simulation run, do not close any of these three software programs. OK!
Thank you, I’m also researching this
It’s really necessary to learn these things! ! ! !
Let’s share our experiences so we can all improve together!