How should the thickness of Asahi Kasei’s electrolyzer gaskets be determined? ?
Thread Content
This post was last edited by sunjl1981 on 2013-1-6 23:31. When using a double-hand hydraulic press to apply gaskets, how should the thickness of the gaskets be determined? That is, which one should use a thicker layer and which one a thinner one, especially regarding the grooves on the middle and at the ends? # hcbbs
The installation of Asahi Kasei’s electrolyzer gaskets differs significantly between the anode and cathode; as for thickness, only the gaskets for the terminal cells are thicker than those of the other cells!
When using Asahi Kasei’s electrolyzer gaskets, the gaskets for the anode and cathode end frames are both thick, and the cathode gasket for the middle frame adjacent to the anode end frame is also thick； Similarly, the anode gasket of the middle frame adjacent to the cathode frame is also thick. The other middle frame gaskets are thin. The thickness of cathode gaskets can be easily distinguished, while that of anode gaskets is not as obvious; however, it is still possible to tell them apart with close inspection, mainly by looking at the wavy areas.