Why can I only draw lines of zero length?
Thread Content
RT, when I suddenly draw a straight line, it shows a length of zero. What should I do?
Zero length? So no matter how you draw it, it’s still just a point, right? Is it because a certain view was selected, which causes lines to be drawn in another plane?
If the problem still cannot be resolved using the method mentioned above, then it’s not an issue related to the view. You can try restarting CAD; it’s a rather cumbersome method, but it should work.
This post was last edited by Yilan Yisheng on 2009-9-8 at 14:27. I wonder why too~ I’ll help boost it for you; if the issue has already been resolved, could you let us know what caused it? http://bbs.hcbbs.com/thread-539911-1-1.html I’m not sure if this post will be helpful to you
There is a view issue in the analysis on the 3rd floor; the solution is to draw additional straight lines within the current view. Draw randomly to see if I can draw it. Use the line command: @length