Why does the dotted line I drew appear as a solid line?
Thread Content
When I use CAD2005 to draw the center line, I obviously choose the dotted line, but when I draw it, it still displays as a solid line. That hero helped me clear up my doubts. Thanks in advance.
Check whether the selected layer in the layer is a dotted line. Don't choose a layer named dotted line, it will be a dotted line. If you do choose a dotted line, try adjusting the line proportion in the properties.
Adjust the line proportion in the feature attributes and make appropriate adjustments to the values inside, and then it will be displayed.
The two guys above are right, you should check it carefully.
http://bbs.hcbbs.com/thread-418017-1-1.html Refer to my post, you need to change a few more data, and also pay attention to the value of the global scale. In addition, as mentioned above: If the line segment is too short, it will not be displayed.
You select the dotted line in your picture, and then keep zooming in and out to see if it is a dotted line in the end. If it is, adjust the line type proportion. If not, the layer is probably not set properly.
Appropriately adjust the linear proportion in the feature attributes. You can choose to regenerate in the view and try it.
The linear proportions are wrong, just adjust them.
Adjust the proportion appropriately. If the proportion is too large or too small, the dotted line will not be visible. Generally, the default proportion is 1.000. You can try adjusting it to 10.000. If it does not work, adjust it to 0.001. Also drawing the lines longer might help!
Select the line properties and adjust the line type proportion. If it still doesn't work, it's a problem with the layer settings.