Why is there a fatal error in my CAD?
Thread Content
Why does my CAD show a fatal error message, even if I uninstall and reinstall it? urgent! ! ! Ask for expert help
I often encounter this situation. It has nothing to do with reinstallation. It is mainly due to the problem of the image being too large or the computer configuration being low. :lol
There is a problem with the installation process. It is recommended to change the installation file.
I've also had this happen to not only my entire office's new computers. Later, I reinstalled the system, and CAD was still the original software. No problems occurred again after reinstalling CAD. Later, all the computers in our office reinstalled the system, and no fatal CAD errors occurred again. Later, I learned that the company's newly purchased computer was installed using a GHOST system disk by a company that sells computers, and this system disk was incomplete, thus causing this situation. You might as well give it a try.
It may be a problem with the operating system. The specific reason is difficult to explain.； I have encountered the same situation before, no matter how I reinstall cad, it doesn't work. If you can reinstall the system, I suggest you reinstall the system.
Thank you for your suggestions. I changed the software and the problem was solved. But the reason for this problem is still unknown. It may be that the software is not good, but I have been using it before. ； It's a system problem, but the system hasn't been changed, but the software can be changed.
Another possibility is that there is an error in the dwg file. A simple method is to use repair to open the file, repair the file and then save it. General errors can be solved. This method is for situations that may occur when opening individual files.