What is panqi? I searched but couldn’t find it!
Thread Content
What is excess steam? I’ve seen in forums that steam that has not been cooled in time after work is done is referred to as excess steam. So, is the steam coming from the reboiler at the bottom of the tower also considered excess steam? Thank you
“Steam that has not been cooled in a timely manner after doing work is referred to as \"waste steam.\" This term isn’t very appropriate, as waste steam has high temperature and pressure, contains less energy, and thus has a very low energy utilization efficiency. “Is the steam coming from the bottom reboiler also called floating vapor? ”If steam comes out of the reboiler at the bottom of the tower, there is a problem with the operation. What comes out is mainly condensed water. The steam in the bottom reboiler utilizes the latent heat of vaporization; the steam undergoes a phase change and is essentially completely condensed into water.
Isn’t it the case that everything coming out of the heavy boiler gets condensed into water! So does that mean that part of it has already turned into water inside!
Hehe, that’s waste steam; check on waste steam. It is steam with a very low quality after doing work. It is relatively difficult to recycle.
What are the general requirements for the steam at the outlet of a reboiler? What impact will an excessive total steam volume have on the condensate system?
The exhaust steam pressure of a certain device after passing through a steam turbine, when using 1.0 MPA steam, is 0.2 MPA； After coming out of the 1.0MPA steam reboiler, it is 0.5MPA after passing through the steam expander
Hehe, since the outlet of the condensing turbine requires a vacuum, there is a condenser at the compressor’s outlet; this condenser contains circulating water that is used to cool the steam being discharged, thereby creating a negative pressure at the turbine’s outlet. This increases the enthalpy drop of the steam and enhances its capacity to do work. However, the condenser cannot condense all of the steam – a portion of it remains as waste steam. The remaining steam is then removed for cooling by an exhaust pump, while any steam that cannot be cooled is usually released into the atmosphere