How to achieve temperature control in Aspen Dynamics?
Thread Content
I want to introduce a heat stream connected to the tank, so as to control the temperature of the tank by changing the duty level. However, it was found that Aspen Dynamics differs somewhat from HYSYS – the heat stream cannot be connected directly to the PID controller. I was wondering if there are any experts who could give some advice? How can one control the temperature of the tank using a heat stream? PS: When I tried to connect the tank using the Control Signal Stream, I found that only P, T, and Level were available; there was no option for duty cycle, which is why I added the heat stream.
If you replace the tank with a heat exchanger, there will be duty
Thank you for the tip; I connected the Heater and Flash2 in series. It seems that using this approach is not as convenient as using HYSYS~