Problems encountered during the PVELITE2008 calculation run

2009-09-25View Original

Thread Content

I would like to ask the experts: after building the model and performing analysis calculations, it shows that no report can be generated, and an error is indicated regarding the thickness. When performing modeling, is it necessary to enter the thickness of each element? How should it be handled? (Design and verification per SW6.0 standards in China; is this the same case for PVELITE2008?) ）

Reply #22009-09-25

Pvelite training manual: http://www.cngspw.com/vbooks/ShowSubject.asp?SubjectID=8006. Go and take a look; it might be useful to you!

Reply #32009-09-25

Whether you are designing or checking, the status bar below pvelite will indicate the calculated thickness and the maximum thickness; if it is displayed in red, it means the calculation has failed

Submit a Project

**Looking for Chemical Technology, Equipment & Solutions?** No Registration Required Broader Platform Exposure | Global Chemical Service Provider Connections

Submit Request — Free Consultation

Disclaimer

This is an automated machine translation of the original thread. Some technical terms may have inaccuracies; the original text shall prevail. Click "View Original" at the top right to access the source page, which supports IP-based automatic real-time language translation. Please watch out for contact details and sales inducements to prevent fraud. All content and translations are for reference only, representing solely the poster's personal views. For enquiries, email service@hcbbs.com.

Problems encountered during the PVELITE2008 calculation run

Thread Content

Related Threads in This Forum

← Previous

Next →

Submit a Project

Disclaimer

Quick Links