Daily 10 Questions in the Moving Equipment Technology Exchange Section – Issue 13

Thread Content

This post was last edited by yxmqh on 2009-10-28 at 12:23. Please hide your replies; otherwise, no rewards will be given! Those who answer all questions correctly in the 13th round can receive a maximum reward of 20 wealth points. 2 Wealth/Question. The hidden method can be viewed by linking to http://bbs.hcbbs.com/thread-492556-1-1.html. Fitter Operation and Measurement Techniques Test: True or False Questions: True or False 11 – Marking complex parts means performing three-dimensional marking. (Incorrect) It is believed that for 2D marking, only one marking reference is needed, while for 3D marking, two marking references are required. (Wrong) Judgment 13: When there are errors in the blank, these can always be corrected by using offset marking. (Incorrect) It is assumed that the plane of the flat plate with markings is the reference plane for those markings. (Yes) Judgment: A thicker coating should be applied to the marked area on the workpiece in order to make the marks clear. (Wrong) It is claimed that the blue ink with 16 strokes is made from an appropriate amount of gentian violet, shellac paint, and alcohol. (Yes) Determine whether all 17 parts must be scribed before processing. (Wrong) It is assumed that the 18th stroke should start from the reference point. (Yes) The underlined concept of \"borrowing material\" refers to adjusting and appropriately distributing the machining allowance of the workpiece. (Yes) Judgment 20: When using a dividing head for marking lines, if the number of rotations of the handle is not an integer, the dividing forks can be used to assist with the division process. ( Wrong )