How to draw CAD cross-hatching lines?
Thread Content
After using the cracked version of Tianyu’s auxiliary design software INTECAD2004, I found that my cross-hatching lines would not appear on other computers. Later, I found that it was gone from my computer as well. I uninstalled Tianyu auxiliary design software, and when I tried to draw again I found that the cross-sectional lines wouldn’t appear. Later, I tried reinstalling CAD 2004 and 2007, as well as reinstalling the operating system, but none of these solutions worked. Have any of you sea friends encountered such a situation? Could you tell me how to solve it?
I personally think the ratio of the profile lines you chose is too large, making it impossible to fill the area; try reducing it a bit
Also, check whether the hatch layer is frozen or something like that; take a look. .