Regarding the issue of furnace column bending
Thread Content
If the furnace column becomes arched and the gap with the protective plate is too large, how should the large and small springs be adjusted? What measures should be taken to stop the further increase in curvature? Please actively participate in the discussion, and it would be best to explain the reasons for any adjustments. Thank you! !
If the curvature is 50 mm or less, it is possible to try loosening the large spring before applying pressure again; after applying pressure, reduce the tension of the upper large spring slightly and increase the tension of the small spring at the lower crossbar – the tension of this small spring should be about 0.5 tons higher than that in other areas