Issues with the Yokogawa engineer station?
Thread Content
The control system used in the workshop is the Yokogawa CENGTUM CS1000 system. Recently, there have been some issues with the engineer station. I would like to ask the experts: will turning off the computer at the engineer station during operation in the workshop cause the workshop to stop functioning?
Please explain what caused the parking issue Was the shutdown triggered by certain process conditions, or was it a system failure?
To ensure the continuity of the V network and the resistance of the terminal circuit, the T-shaped connector can be removed from the VF701 card so that it can be dealt with. Disconnecting the power supply separately will not affect production, but an alarm will be triggered.
It’s just an engineer’s station; even if you destroy it, it won’t have any impact
The program that is executed is installed within the FCU of the FCS, not on the engineer station; the engineer station is used only for configuration and maintenance, so it’s fine to shut it down – there are other HIS systems that can be used instead.
Stopping the DCS system engineer station I have used does not affect the operation of the system. The engineer station is only used for configuration. Yokogawa’s CS system operator station cannot be used for configuration. The operator stations of other DCS systems can be used as engineer stations.
Absolutely not. The engineer station is only used for configuration and downloading, it is not a server.