Issues with boiler installation contracts
Thread Content
Generally, is it the boiler installer’s responsibility to carry out equipment cutting? For example, if the length of the water wall tubes exceeds 10–25 mm, is the installer still responsible for carrying out such cutting? Thank you
They should be held responsible, but it depends on what’s specified in the contract. As the original poster mentioned, it’s better to refer to relevant standards such as JB1611 and 5255, which outline the technical requirements for manufacturing membrane walls or pipes. According to what was said above, a thickness of 10–25 mm indicates a manufacturing or design error; therefore, the installation company should charge a fee or request that the manufacturer take care of it
You can contact the supplier directly; they will find a solution, so you don’t need to worry about it
First, it is necessary to examine the technical terms of the installation contract to see whether they specify the handling methods and the requirements regarding installation accuracy； Secondly, from the perspective of the equipment manufacturer’s design, this is a technical section reserved during installation to compensate for installation errors; the manufacturer is not responsible for dealing with it! In summary, the construction party must resolve it on its own!
There’s no need for discussion; those who make the decision must take responsibility