How to store pump shafts
Thread Content
This post was last edited by yxmqh on 2009-12-17 19:42 Dear classmates and seniors: Does anyone know how to store the pump shaft (including the rotor)? Are there standards for flat laying, lifting, and special brackets? Thank you in advance!
The rotor cannot be laid flat. If it takes a long time, it may cause the rotor to bend. It should be hung up with a bracket for storage.
Large rotors cannot be hoisted and can only be supported by brackets.
Large rotors cannot be hoisted and can only be supported by brackets.
Shafts must be hoisted and stored, and large rotors require special brackets.
Thank you for the discussion upstairs! Can anyone find more detailed standards or instructions? Thank you!
In order to prevent the rotor from bending, the rotor of the general pump is lifted； The rotors of large units are set up with brackets, sealed, and protected by nitrogen gas.