Procedures for dynamic welding of chemical equipment
Thread Content
Most of the materials in chemical installations are flammable and explosive. When using electric welding in the installation, you must apply for hot work, and the welding workers must have a hot work certificate. Which departments should be responsible for these two tasks and which personnel should be responsible for them? Thank you for your help.
It should still need to be analyzed! If you want to make a fire, go to the safety and environmental department. For analysis, go to the analysis room!
The workshop safety officer should go to the safety department to handle the matter, and the safety department will review and approve it after on-site analysis.
Depends on which department you are in, assuming you are* * If you are an engineering company, then you must first have a formal written letter or a contact sheet with an official seal, etc., and send it to the other company, and let the leader of the other company arrange for the workshop and safety and equipment departments to handle it. If you are moving chemical equipment, you must first get a production license from the workshop, arrange for cleaning and replacement, the analysis department will pass the analysis, the equipment department will hand over the equipment, and the safety department will issue a fire permit. This is probably the procedure. The most important thing is that you need to find the vice president of production or a powerful leader of the company. They can get it done with just one phone call. Otherwise, if the ball is thrown, no one will be willing to handle it for you. After all, it is risky!
Our company implements a regional responsibility system. As long as you start a fire in your area, the leader of the fire area will be responsible for inspection, approval and fire supervision when approving the hot work.
Please consult your company's safety and environmental department. This depends on the company's regulations and is different for each company.