Common faults, causes, and solutions for Roots blowers

Thread Content

:) Common faults, causes, and solutions for Roots blowers Fault Possible causes Solutions 1) No flow at the outlet 1) Too low rotation speed 2) Incorrect rotation direction 3) Clogged pipelines 1) Measure the rotation speed using a tachometer and compare it with the values specified in the manufacturer’s documents 2) Adjust the motor’s rotation direction 3) Inspect the pipelines, protective screens, valves, and silencers to ensure unobstructed airflow 2) Low air volume 1) Too low rotation speed 2) Excessive pressure at the outlet 3) Clogged pipelines 4) Severe leaks 1) Check the belt and adjust its tension 2) Check the vacuum level at the inlet and the pressure at the outlet 3) Inspect the pipelines, protective screens, valves, and silencers to ensure unobstructed airflow 4) Check the exterior of the casing for any wear or rust that could cause gaps 3) Overload 1) Too high rotation speed 2) Excessive pressure 3) Friction between the rotors 1) Check and make adjustments as necessary 2) Check the pressure at the inlet and outlet 3) Check the exterior of the casing for any hot spots where the rotors might be in contact; improve the installation of the blower and the alignment of its shaft. 4) Overheating of gears or bearings 1) Insufficient lubricating oil 2) Excessive lubricating oil 3) Excess pressure at the outlet 4) Misalignment of the coupling 5) Tight belt 1) Check the oil level in the gear oil tank and the pressure in the lubrication system. 2) Check the oil level in the gear oil tank as well as the pump pressure; if these values are incorrect, drain the old oil and replace it with new lubricating oil of the recommended grade. 3) Check the pressures at the inlet and outlet. 4) Realign the components. 5) Adjust the belt tension again. 5) Vibration 1) Misalignment 2) Friction between rotors 3) Wear of bearings and gears 4) Imbalance or friction in the rotors 5) Loose motor or fan 6) Resonance in the pipes 1) Realign the components. 2) Check for any hot spots on the outside of the casing, as contact there may be causing the problem; improve the installation of the fan and the alignment of the shaft. 3) Check the gear mesh clearance and the condition of the bearings; replace the gears and bearings as necessary. 4) Remove rust and other impurities to restore the proper clearance, then re-establish dynamic balance. 5) Tighten the mounting bolts. 6) Determine whether standing waves are forming in the pipes :loveliness: