How to draw floor steel plates in CADworx
Thread Content
When I use CADworx to draw floor steel plates, why do I always get aggregation line errors and cannot draw floor steel plates? I use line mode, and point mode sometimes works, sometimes not. In addition, I hope that the floor steel plates are grids, but I can't seem to find them in CADworx. How can I set them up? Thank you.
The command line always gives this error: An incorrect polyline type appears... Does anyone have a good solution? :shutdown:
The grid is realized with filling. As for the convergence line error, is it because you used L to draw it instead of PL or
Thank you, I will go back and study it again! :):)
I also learned something about the difference between polylines and straight lines.