Reasons for material leakage between filter plates in plate and frame filter presses
Thread Content
This post was last edited by sunjl1981 on 2013-1-6 21:21. 1. Insufficient oil pressure； 2. There are debris between the filter plates ； 3. The filter cloth is uneven and has folds ； 4. Deformation of the filter plate ； 5. The feed pump pressure is too high. # hcbbs
1# wu*an3522 The main reason is that the check valve in the oil circuit cannot maintain pressure, causing the pressure pump to start frequently； Second, during operation, minerals stick to the filter cloth due to lack of care
One more thing: the sludge is not removed in a timely manner. :lol
One more thing: The operating procedures aren’t fully mastered; it is recommended that the original poster take them home and study them carefully*, rather than posting them here. Suggestion 1: The poster should not post similar threads. If there really are no other topics to post about, they may share their own production experiences or lessons learned, or any questions they have that they don’t understand. Suggestion 2: The moderator should delete such posts
The filter cloth model also has an impact on the solid content of the salt sludge. Attention should also be paid to the installation of the filter cloth.
If possible, leak testing should be done.
If the width of the sealing strip is insufficient, poor sealing can also lead to material leakage (spray of slurry).