How to modify pipeline levels in Autoplant and the issues that occur with diagram rendering
Thread Content
This post was last edited by inssun on 2010-3-10 21:10. 1. The pipelines have already been installed, but the new version of the P&ID changed their levels. How can I modify the levels of these already-installed pipelines? We have updated the pipe end information and the pipeline number, but the grade in the pipeline’s properties still hasn’t changed. Do I have to delete it and start over? 2. When switching to the front view and left view, and at the step of inserting the diagram into the layout, it is found that only a certain area is displayed in the layout; the devices and other elements within that area are not shown. However, when switching to the top view, the diagram is displayed properly. What’s going on?
I really admire the courage of the original poster – to take on a project when they still only had a partial understanding of the software. Truly admirable. Hehe~
1. UPDATE can update the level； 2. Pay attention to setting the depth of the rectangle~
2# hjfang Haha, I’ve always used PDS and PDMS； The project required the use of Autoplant, but there were few people in the company who knew how to use it; they were sent to work on the project right after completing the training, and such skills weren’t covered in the training program. To make matters worse, the administrator was on a business trip at that time. . . Personally, I find it less user-friendly than PDS