Industrial lining brick types

Of course there are many other kinds besides what you mentioned: 1. Carbon plate lining, carbon brick lining: The main control points include the selection of cement, the mix ratio and the amount of diluent added, the thickness of the bonding layer, the width of the mortar joints, etc. ； 2. Water glass cement lining acid-resistant board: Water glass selection and module control and other aspects! 3. Resin clay lined acid-resistant board. Of course, these construction specifications and requirements can be seen in the relevant specifications!

The main types of industrial lining bricks are: Standard acid-resistant bricks, clinker bricks, flat acid-resistant bricks, acid-resistant ceramic boards, cast stone slabs, granite and other stone blocks. Before paving blocks, it is advisable to test the arrangement first ； When paving, the order of paving should be from low to high, first pit, trench, then floor, skirting board or dado. The facade blocks at the inner corners should press the flat blocks, and the flat blocks at the outer corners should cover the facade blocks. There should be no cross seams in block paving, and no overlapping seams in multi-layer blocks. The paving of blocks should be done by kneading, and the paving of granite and other stone blocks should be done by the slurry method. The bonding layer and mortar joint cement or mortar should be full and dense, and measures should be taken to prevent the blocks from slipping. When paving blocks, the joints should be filled and compacted before the initial setting of cement or mortar, and the surface of the mortar joints should be smooth. At the same time, pointing and filling joints should meet relevant requirements.