Aspen split error
Thread Content
I’m using Aspen11.1; I recently learned about simulations using split! Simply put, for example, if I want to check the azeotropic behavior of methanol, water, and ethanol! After entering the components, I click on Tools--Aspen Split---Azeotrope Search--and then select the components! This is why the dialog box “failed to get completion status” keeps popping up; I’m really worried! I hope the experts here can help me figure out what went wrong! The D software simply can’t do it! ! Appendix ； I have installed the split module!
Have you chosen the thermodynamic method?
Does the control panel directly remind you to enter it to complete it (⊙ o ⊙)? Under normal circumstances, what you refer to as A+ can indeed be achieved
2# li*aohong0311 chose unifiac for thermodynamics
I used the UNIQUAC equation as an example and found that the Azeotrope search method can be utilized. I think the run type for this process should be flowsheet; you need to select the FLASH or HEATER module and set the conditions and flow rates of the feed. After running the process, you can then use the Azeotrope search method, and no problems will arise.
What was said on the 5th floor is correct; it would be best for the original poster to upload the simulation files, as that would make things easier to resolve
5# li*aohong0311 Extremely frustrated! I just uninstalled 11.1! 2006 has been installed! One more thing to add! To prepare this azeotrope, it’s not necessary to use a FLOWSHET, right? It can be easily found using the 2006 version! My personal opinion is that there are problems other than those that occur during software installation!