Utilization methods of gas at the top of normal pressure tower and vacuum tower
Thread Content
To utilize the gas at the top of the atmospheric tower and vacuum tower, our device directly vents it. Unfortunately, we also have a low-pressure gas burner, but the top of the tower is under pressure and cannot be used.
There are old devices that just connect a pipe to the heating furnace and burn it casually. It should not be suppressed. It is better than venting.
This is more dangerous 2# dongliangsir
Add a small compressor to boost the pressure and send it to the catalytic air compressor.
Add a small compressor, as I told the brother above, but you have to confirm its composition. You can calculate the amount of C3 and C4 after testing.
Can I add a small high-pressure blower?
The normal pressure gas in our installation first passes through the liquid separation tank and then goes to the normal pressure furnace to be burned!
Our normal reducing ceiling gas also passes through the liquid separation tank, then passes through the flame arrester and then enters the furnace to be burned. There is no holding back the pressure.
Our normal pressure gas goes into the normal pressure gas tank, and then goes into the normal pressure furnace through the flame arrester.； The decompression gas is also brought close to the decompression liquid separation tank, and then burned in the decompression furnace. However, the excess is very small. Currently, in production, the combined burner is used and burned together.
The normal-reducing ceiling gas in our installation passes through its own liquid separation tank, and then passes through the flame arrester and then enters the furnace to be burned. There is no pressure to hold back