What knowledge does an instrument repair technician need to possess?
Thread Content
When we were in school, what were the specialized courses in fashion design? What knowledge do you think instrument repair technicians should possess most?
Just go to the bookstore and buy a mechanic’s manual; that will solve the problem.
Books should be read, but the most important thing is to learn on the spot*.
I did not major in instrumentation when I was in school. Read more books, get more hands-on experience, seek advice from experienced professionals, thoroughly understand the area of work that falls under your responsibility, and then communicate more with your peers. That should do it
The topic posed by the original poster is too broad~~ The specialized courses studied in university are all relevant in work~~~
To do a job well, one should master all knowledge other than specialized expertise. It’s just that due to the shortness of life, it’s difficult to do so; hear **one saying: live and learn throughout your life.
Haha, good suggestion; I want to know that too. Following
It depends on the standards you set for yourself. The minimum requirement is to be familiar with the types, principles, and common faults of instruments used in the field. At a slightly higher level, one should be able to select the appropriate instruments based on different situations. At an even higher level, one needs to understand control principles and be capable of designing various small-scale automatic control systems according to process requirements. If you have higher aspirations, then studying control systems is essential. The depth of study required at each stage varies as well... If you want to learn the basics, that’s possible; but if you want to go deeper, there’s a lot more to learn. All I can say is that hard work leads to good results...
First, you need to figure out which instruments need to be repaired. Then, find out how these instruments work by consulting books or the internet. After that, apply that knowledge to learn how to repair them on site. This is the best way.
I think it’s good to learn some knowledge about communications; I feel this kind of knowledge is often overlooked
What I think is necessary to know for working with instruments: some knowledge of manufacturing processes, some knowledge of electrical systems, some knowledge of fitting work, some knowledge of piping, some knowledge of lifting operations, some knowledge of insulation, some knowledge of painting, some knowledge of installation, some knowledge of materials, and more knowledge specifically related to instruments. In short, working with instruments is very exhausting; the more you learn, the less you seem to understand.