Let’s discuss which parts or operations of catalytic cracking can easily cause harm to people.
Thread Content
This post was last edited by a refinery worker at 2010-4-16 10:50. Let’s discuss which parts or operations of catalytic cracking can easily cause harm to people. As the saying goes, if you often walk by the water, your shoes will not get wet. When you see some colleagues getting injured, you should be careful. But there are still many unexpected places, please discuss. At that time, because one of the regenerators was loose and blocked, we had to deal with it. As a result, the catalyst came out and burned our face. There was also a case where the liquefied gas was discharged from the vent and there was a power connection box around it. It caught fire and burned it. Let's give some examples for future safety.
There will be certain risks in any job. You must abide by the procedures, implement the plan, think for three minutes before doing the work, and think through everything you can think of before doing it! ! !
When walking, try to see the environment in front of you clearly before entering the work area. Analyze the best evacuation route in case of a situation in advance. Don't panic when you encounter problems. There will definitely be problems when you are nervous! You must fully analyze and understand the content of the assignment before doing it! ! !
When the pressure test was started, a valve cover leaked. A colleague was about to remove it and replace the gasket. He cut out the valve and vented it, which also reduced the pressure. As a result, the valve stem collapsed as soon as he removed it and the steam burned it. I really don’t know how to pay attention to it.
Generally speaking, when working in chemical companies, the first thing to pay attention to is the "three no harms". After improving your own safety awareness, you can reduce many problems. Also wear protective equipment correctly. It can also reduce the damage in this area. What I mean is that as long as you pay attention and raise your awareness, you shouldn't be hurt.
I think when implementing specific operations, you must know what you are doing wrong. Even if the leader asks you to do it, you cannot do it. Many employees are just dawdling and do not know what they are doing.
It is difficult to summarize it in one sentence. In short, before doing every job, you must strictly abide by the operating procedures, use the "five-minute observation method", do a good risk assessment, and think clearly before doing it. You must be cautious and don't act too hastily.
You are out, and now you are four without harm! Don’t hurt yourself, don’t hurt others, don’t be hurt by others, protect others from being hurt! ! ! ! ! Hahaha, in short, don’t go to work! ! And don’t watch others working! ! Don't be there! ! ! Otherwise you will be banned! ! ! Haha, Sinopec’s 5# maxupeng1025
The above is the reply to the fifth floor! In fact, everyone should be careful with any medium with pressure and temperature, not just in the reaction area, but everywhere! And don’t put too much faith in so-called thermometers and pressure gauges, especially this pressure gauge! ! ! For example, if your watch is 2.5mpa, and you see that the pressure has reached zero, if you change it to -0.1------0.1mpa, you will find that the pressure may be 0.08mpa. If the medium is hot or toxic, you will be in trouble if you open it! ! ! Also, F=PS, if you calculate a flange with a diameter of 100mm, the strength is 0.8 * 3.14 * 5 * 5=62.8kg, what effect will it have if it hits you? ! Just go and carry three big buckets of Wahaha and you will know! Therefore, no matter what you do, you must be careful. You would rather believe something than trust something else. You would rather do it slowly than violate the operating procedures. Everything you do must be done according to the rules! ! Otherwise, if you make a mistake, you’ll get it all! ! Alas, work is difficult! !
You must first understand the situation clearly and strictly follow the operating methods to minimize the occurrence of accidents.