In ASPEN, set to display the properties of the gas and liquid phases separately
Thread Content
In a multiphase system, I want to see the densities of the gas phase and the liquid phase separately, but here only a combined density is displayed. How do I set this up? ! Could some expert give me some advice?
Just add a gas-liquid separator, that’s it
In Report Option --> Stream --> Property Sets, add the property set; then in the result selection, you can choose GEN OR FULL. This is quite easy.
After adding them, it crashed; calculations could no longer be carried out. -> Processing input specifications... The binary parameters PRKIJ (DATA SET 1) for the ESPRSTD model are retrieved from the SDF table. Table name = ESPRSTD. The binary parameters RKSKIJ (DATA SET 1) for the ESRKSTD model are retrieved from the SDF table. Table name = ESRKSTD. The pure component parameters for certain components are obtained from the SDF table. These parameters are used with the ELECNRTL option set, unless you enter your own parameters in the PROP-DATA sections. The parameters retrieved for the H2O component are: VLBROC. The plant parameters retrieved for the CO2 component are: VLBROC. * WARNING: In the “STREAM-REPOR” section, starting on line 212, both the INCL-STREAMS and EXCL-STREAMS entries are specified in the stream standard report; only the INCL-STREAMS entry is processed. **** EXECUTION ERROR: Unable to load the dynamic library CHEMAPP! Calculations were terminated due to internal errors in ASPEN PLUS. 3# greatcharm
Reply to 4# lantianke0918: This problem has been bothering me for a long time, and I still haven’t managed to solve it. Has the hero found a solution?