How can you learn about SW6?* of?
Thread Content
I used to do heat exchanger process calculations, and now I want to learn* There is no one to teach me about pressure vessel design. I downloaded a SW6 software from the Internet and taught myself. It is relatively inconvenient to learn. How does everyone learn * Use this software?
You are from a craft background, so it would be very difficult for you to come up with equipment halfway. Fortunately for SW6, once you understand the selection of various parameters, it's almost enough. With the calculation results, the work is only half completed.
Yesterday I went to the design institute to ask an engineer about learning in this area.* material. He asked me to take a look at GB150. Alas, it’s another university question.
Familiarize yourself with GB150 and HG20582 first, and then use SW6. It's very simple.
In many cases, the parameters of this equipment are different and the selection is different. If you have never used the equipment before, you don’t know how to choose it. It is better to get a piece of equipment to do it and then it will be almost the same all the way. The types are different.* Pressure vessel design is not the main * sw-6 ah...
SW6 is just a calculation software, you should focus on learning* Standards and specifications
SW6 is just a software for equipment calculation, process transfer to equipment, I don’t know if there is any progress.
Following the suggestion on the 4th floor, I went to look for the HG20582 book and read it. Oh my god, that book is so thick! I gnawed some of them! Thank you!
SW6 is written in accordance with GB150, GB151, etc. You must first be familiar with these standards.