Dead zone of ultrasonic level gauge
Thread Content
How should a Rosemount ultrasonic level gauge be installed? How to calculate his measured dead zone?
This post was last edited by zenxg04 on 2010-5-10 at 14:21. The maximum liquid level in the medium should be between 30 and 60 cm from the ultrasonic wave emitter; if the measured liquid level is several dozen meters, it should be adjusted to around 1.5 meters instead
Typical blind zones of ultrasonic level gauges: Range Blind zone 0–4 meters: 0.25 meters 0–8 meters: 0.4 meters 0–15 meters: 0.5 meters These values are for reference only; the blind zones vary depending on the technology used by each manufacturer.
3# zhangleitong is generally 50CM
There are roughly two installation methods: threaded (flange) and fixed-hole (bracket). The so-called measurement dead zone mentioned by the poster is what is also known as the blind zone. The blind zone varies depending on the range of the instrument, but the differences between different manufacturers are not significant. As for the specific installation methods and parameters, it is necessary to refer to the user manual or instructions provided with the product in question. This is not an advertisement; my QQ number is 84656995
It is recommended that the poster check the user manual; the manufacturer provides instructions there