I have a question regarding liquid level
Thread Content
This post was last edited by Benbenxuan on 2010-5-13 at 10:53. There are two tanks, one with a height of 5m and the other with a height of 3m. The pump is designed to draw water from the 5m tank; the outlet of the 3m tank is connected to the pump. Will the liquid in the 5m tank push its way into the 3m tank? file:///C:/DOCUME~1/DIAODU~3/LOCALS~1/Temp/ksohtml/wps_clip_image-0.png
The image can’t be viewed; please provide the pump parameters
Provide the piping diagram and the installation heights of each device, including valves
The pump inlet pipe is connected to the bottom of the 5M tank, while the pump outlet pipe is connected to the lower part of the 3M tank. Therefore, when the liquid level in the 5M tank rises above that of the 3M tank and the pump’s inlet and outlet valves are not closed, it is possible for liquid to flow into the 3M tank
4# sxydxy3 agrees with your conclusion.
4# sxydxy3 agrees with your conclusion.
4# sxydxy3 agrees with your conclusion.
Thank you; practice has shown that those with a higher height will press down on those with a lower height, so it was modified later.
I don’t know what your purpose is. If the process requires a 3m tank that you can’t obtain on your own, then you’ll need to install a check valve, right? If not required, it can be pressed into a groove 3m deep based on the height difference alone!
The goal is to mix the oil from the 3-meter tank with that from the 5-meter tank, but it’s not a 1:1 mixture – there is less oil in the 3-meter tank and more in the 5-meter tank; therefore, in practice it proves difficult to control the amount of oil added from the 3-meter tank. So the position was raised.