Urgent! Urgent! Urgent!
Thread Content
How long is the best testing time for a pump at the moment of startup? For the motor, for the pump body, thank you!
The purpose of conducting a test run is usually to check the motor’s direction of rotation and to see if there are any noticeable vibrations, etc.; generally, the test stops once the pump starts rotating.
There are no special requirements; when testing a newly installed pump, the direction of rotation is checked. As a general rule, after the operator presses the start button, they count silently to one or two and then stop the pump immediately.
Just call it and give it a try; it stops as soon as a little is used
The spot test is mainly used to check whether the rotation direction of the motor is correct; once the motor starts rotating after 1-2 seconds, it is possible to determine its rotation direction.
A spot check generally involves checking the rotation direction of the motor and pump; it is mainly a preparatory step after equipment maintenance or before rotating the equipment, and it does not take much time.