The 3K compressor has a single-unit reflux; where is the most suitable location for the overall reflux of the chlorine system?
Thread Content
This post was last edited by sunjl1981 on 2013-1-7 00:11. The 3K compressor has a single-unit return flow; where would be the appropriate location for the overall return flow of the chlorine system? Share your opinion.,, -
It’s better to go back to the chlorine scrubber tower!
The overall reflux is primarily intended to compensate for the pressure at the compressor inlet. If it is connected before the scrubber tower, the significant pressure drop in the section leading to the compressor inlet may prevent timely adjustment of the compressor inlet pressure. Additionally, an increased pressure difference before and after the drying combination tower could also result in an increase in the amount of acid carried along. Furthermore, its impact on the pressure in the main chlorine electrolysis pipeline is very direct and frequent, which may hinder the stable balance of the electrolysis pressure. So personally, I think it might be more appropriate to place it after the acid mist collector?
We return from the acid mist collector outlet to the bubble column outlet.
Our chlorine main pipe has two return lines: one leads directly from the chlorine distribution station to in front of the scrubber tower, and the other leads to the inlet of the bubble column. These two return lines are very useful when there are changes in load or fluctuations.