Has anyone used this kind of pump? Can you recommend it to me? Thank you.
Thread Content
This post was last edited by shyitai on 2010-6-13 16:22. I searched many pump factories, but none of them had relevant equipment, which was really frustrating. . Because the customer needs such a test pump, the parameter conditions are as follows: 1. Work flow: 0-50ml/min ； 2. Work pressure: Maximum 3MPA; 3. Working temperature: Maximum 350 degrees ； 4. The medium is similar to oil and non-corrosive ； Can any prawn give me some advice? . Any help is greatly appreciated. . . ! ! !
You can use a metering pump, and the flow and pressure are no problem. As for the temperature of 350 degrees, it still needs to be determined by the pump manufacturer. I hope this reply can help you.
Please find some metering pump factories in Dalian, the problem is not difficult to solve, such as Riva, Promonte, etc., no problem.
A metering pump is enough, but the temperature is a bit high, so you have to pay attention to whether there are pulses.
The temperature needs to reach 350 degrees, which is a bit high, but 200 degrees is fine. You can go and see this factory. http://www.zjtdby.com/product.asp?id=820
Such a high temperature. I guess I need to ask about using a plunger metering pump. Can you ask the OBL metering pump agent if they can do it? We have used OBL metering pumps before, which is pretty good.
It seems that Prominte's pump is not able to reach 350 degrees. The plunger pump is only about 120 degrees, not more than 150 degrees. You probably have to make this custom-made!