Use of heat exchangers in the sulfur recovery industry
Thread Content
This post was last edited by Shandong Huaxing on 2010-7-15 01:38. I would like to know which stages in the sulfur recovery industry use heat exchangers? Could a professional provide a as detailed an explanation as possible? Thank you!
This post was last edited and replied to by Shandong Huaxing on 2010-7-15 01:38. Reply 1# Tsunami is coming, run! There are many places in need! Possible applications (excluding the exhaust gas treatment unit) include: 1. Two units for preheating air and feed gas. 2. The waste heat exchanger located after the combustion furnace; it can also be considered a heat exchange device, 1 unit in total. 3. Three units for indirect heating at the inlet of the three-stage Claus process. 4. Three condensers at the outlet of the three-stage Claus process; these can be combined together. That’s all I can think of for now.
The heat exchangers used in the sulfur recovery unit include: four acid gas waste boilers, four flue gas waste boilers, four preheaters, four condensers, and air coolers.
There are many components in the exhaust gas treatment section: quench water, rich and lean fluids, air cooling, and plate exchangers.
This post was last edited by Shandong Huaxing on 2010-8-8 21:56. Exhaust gas heaters, steam generators, steam superheaters, quench water coolers, primary, secondary, and tertiary condensate coolers, process gas heat exchangers, waste heat boilers for sulfur production, etc.
I would really like to know too. . . . . .