Questions about CAESAR II modeling
Thread Content
Dear fellow marine engineers: I’ve been self-studying CAESAR II recently and have some questions; I hope experts can help me answer them: 1. Should the dimensions of elbows be included in those of the straight pipes? For example, if the length of a straight pipe is 2000 mm, should I enter 2000 mm directly in CAESAR II, or 2000 minus 1.5D? 2. Should tees and reducers be entered separately in the data table of a new unit, or in the same way as elbows?
Simply enter the elbow at the end of the 2000mm node; a reducer is used for reducing the diameter, while SIF&TEE is used for tees
1. Is the size of the elbow specified within the length of the straight pipe? For example, if the straight pipe is 2000 mm long, should 2000 mm be entered directly in CAESAR II, or should 2000 minus 1.5D be used? A: 2000 mm should be entered directly, and then the value for the bend is considered. 2. Should tees and elbows be entered separately in their own data fields in the new unit, or in the same way as elbows? A: Tees and elbows are entered in a similar manner; reducers require separate entry
The field of stress analysis is concerned with the stress conditions at various nodes, and based on these conditions, it analyzes the stress on the entire pipeline as well as its impact on other related elements. It seems like the poster might have worked on 3D models before