Is a ball valve leaking due to excessive pressure?
Thread Content
There seems to be some issue with the three-piece plug-and-socket ball valve that is welded onto the tank truck; leaks are occurring at both ends of the valve’s seal, and the pressure is 6.4 MP! I’d like to ask everyone for advice! ! ! Thank you. Is it due to too much pressure? ? ? ? It’s urgent! ! !
It’s also possible that the sealing is not good enough.
Check the sealing surface; it seems to be damaged.
This is likely caused by excessive pressure of the medium acting on the valve; the pressure in the pipeline may be close to the valve’s maximum tolerance value. Using a valve rated for 100 bar should resolve the issue. QQ: 120519927
Could it be that poor welding caused the leakage?
Thank you all. I went to the factory today and it seems that the sealing isn’t proper; applying sealant will prevent leaks! ! ! Safety first – it’s time to replace the padding! ! !