Question – How to determine the length-diameter ratio?
Thread Content
This post was last edited by jia717 on 2010-8-19 at 19:33. How is the length-diameter ratio of a vertical storage tank determined? What are the bases? Thank you
Sigh, why isn’t anyone replying?
http://bbs.hcbbs.com/search.php?searchid=1586&orderby=lastpost&ascdesc=desc&searchsubmit=yes Try searching there yourself; it should be helpful to you!
Generally, 3 to 5 times D is used; in fact, high pressures usually don’t require this approach, otherwise the cylinder wall would become too thick
The specific conditions of your equipment are not clear. If it is a low-pressure storage tank, the ratio can be determined based on the actual installation and operating conditions of the equipment; generally, a ratio of 1:2 is sufficient. If the pressure is relatively high, this ratio can be increased slightly. In any case, it is necessary to take into account the inspection holes to facilitate the installation and maintenance of the equipment
Thank you all; I’ve found it already. I’m still very grateful
Generally, 3 to 5 times D,l is considered ideal