Aspen simulation absorption analysis cycle system
Thread Content
Could some expert please advise: when using Aspen to simulate a circulation system for absorption and desorption, how should the feed of the absorbing liquid be specified, and how should the circulation be set up?
It’s estimated that it involves cutting off the flow rate; in Aspen, this can be calculated directly.
Reply to 2# muzili2008: So how exactly is it done? Is it to disconnect the part where the logistics are specified, and then modify the initial value to match the specified value? Isn’t that just manual iteration?
I think it’s possible to first disconnect the simulation to obtain the initial values, and then close the loop to fill those initial values into the corresponding positions within the loop; this should resolve any issues