Fluctuations in the inlet temperature of the transformation system? How to better adjust operating conditions?
Thread Content
Under the low water-vapor ratio process! !
Is what the poster is referring to the fluctuations in the inlet temperature of the converter? If the fluctuation in the inlet temperature of the transformation system is the issue, it is caused by problems with the water flow rate in the cooler at the compression unit; adjusting the outlet temperature of the compression unit’s system will resolve this issue ； If it is the fluctuation in the converter inlet temperature, adjustment can be made using Converter 1# bypass.
I wonder what type of process the original poster uses: medium-low-low, medium-middle-low, or all low?
It would be best to explain the process used, as well as what the composition of the imported gas is
Is the poster referring to the inlet temperature of the converter? It’s best to briefly explain the process so that everyone can analyze and solve it more effectively.
It would be best if the original poster could send over a copy of your process flow; I’m sure I can help you solve this!
Describing the process flow can help in analyzing problems.
For different process flows, the factors affecting the inlet temperature of the converter vary; therefore, knowing the process flow is necessary in order to facilitate analysis.